Transmet I.S. is an easy to install, self-contained dew-point transmitter for the measurement of the moisture content of flammable and non-flammable gases, and has been specifically designed for use within hazardous areas. Housed in a stainless steel case, Transmet I.S. offers ingress protection to IP66 (NEMA 4X).
With a wide operating range from -100 to +20°Cdp and accuracy of up to 1°Cdp it is the most complete dew-point transmitter available. Transmet I.S. has a fast response speed that gives the user a continuous measurement in real time. No configuration or calibration is necessary - the Transmet I.S. is delivered configured and calibrated, ready for installation and operation
Caratteristiche del prodotto
ATEX, FM & CSA approved
Wide measurement range
Calibrated -100 to +20°Cdp
Best accuracy ±1.0°C
Fast response
30 MPa (300 barg) pressure rating
Rugged IP66 (NEMA 4) enclosure
Specifiche Tecniche
Sensor Thread
5/8" UNF parallel
Case
Stainless steel
Ingress Protection
IP66 (NEMA 4X)
Power Supply
10 to 28 VDC (regulated or unregulated DC supply)
Reverse polarity protected
Outputs
Current sink: Analogue 0-20 mA or 4-20 mA selectable linear
corresponding to °Cdp
Measurement Range
-100 to +20°Cdp
Accuracy
±1°C from +20 to -59.9°Cdp
±2°C from -60 to -100°Cdp
±0.3°C temperature
Resolution
0.1°C from -80 to +20°Cdp 1°C from -100 to -80°Cdp
0.1°C temperature
Operating Temperature
-20 to +60°C
Storage Temperature
-40 to +70°C
Operating Pressure
From vacuum to 30 MPa (30 barg)
Flow Rate
0-10 l/min
Gas Velocity
20 m/sec (max)
Barrier Options
System 1: shunt diode barrier (IS earth required)
System 2: galvanic isolation barrier (no earth required)
OPTIONS:
Sensor sampling block, display unit (Cermet II I.S.), power supply module
A range of sampling systems are also available
Applicazioni
Prodotti correlate
Easidew TX
I.S. L'Easidew Transmitter viene rilasciato con un proprio certificato di calibrazione tracciabile secondo gli standard internazionali dei laboratori in Michell accreditati UKAS...
Easidew PRO I.S. L’Easidew PRO I.S. è un trasmettitore di dew point a sicurezza intrinseca progettato allo scopo di fornire un...
Cermet II I.S. Trasmettitore di dew point a sicurezza intrinseca per misurazioni online in aree pericolose...
Promet I.S. Sistema chiavi in mano per la misurazione di umidità in gas critici di processo...
Promet EExd Sistema progettato principalmente per l’utilizzo in aree pericolose per applicazioni critiche...
MDM300 MDM300 è un sistema completo per la misura dell’umidità in qualsiasi applicazione industriale...
Liquidew I.S. Liquidew I.S. prodotto da Michell, e un analizzatore in continuo del contenuto di umidita nei liquidi estremamente accurato,
